But for temporary use, there are better options. If you’ve got no better option, it’s a perfect solution for long-term installation. Needless to say, using a molex to SATA adapter isn’t always the best solution. Using the wrong adapter will void your hard drive’s warranty, turning even a brand-new drive into a brick. In our reviews, we’ve tried to explain what voltages and drives are best-suited for each-other. Make sure you’re using the right voltage cable for your drive, and all should be well. That said, there are some quirky adapters and quirky drives on the market. Most adapters support both of these options. Typically, most SSDs use 5.5-volt power, and most HDDs run on a 12-volt current. If you’re not paying attention to your drive’s power requirements, you can easily cause damage.
#HDD MOLEX CONNECTOR PC#
However, there’s another way to damage your PC with a molex to SATA adapter. We’ve chosen well-designed molex to SATA adapters, so this shouldn’t be a problem. More likely, it will damage your hard drive, and can even cause a fire. At the very least, this will destroy your adapter. Instead, the arc will melt through the plastic insulation until it shorts out to another voltage line. However, because the current is initially diverted to the ground cable, safety shutoffs will not trigger. Normally, a short of this nature would cause your PSU’s safety features to trigger and shut off the current. In a poorly-manufactured adapter, power can arc from the 5.5-volt or 12-volt wire to the ground wire. This is essential, because poor shielding and tips are the cause of our safety concerns. Look for good shielding, and a tip that’s crimped, not molded. The first thing to do is to choose an adapter that’s properly manufactured. It’s a 1TB drive that installs quickly and painlessly. If you’re interested in going this route, check out our review of the Kingston KC2000. On the other hand, it also ties up one of your PCI Express slot, limiting your options for future upgrades. Some newer SSDs plug directly into your PCI Express slot, eliminating the need for a SATA cable altogether. Then plug your hard drive into the other end, and you’re good to go.Īs SSD drives have gotten smaller and smaller, you actually have a third option. Instead, all you need to do is plug the adapter into your PSU. By going this route, you won’t need to worry about swapping out your power supply. Replacing a power supply is equivalent to major surgery.Īnother option is to use a molex to SATA adapter cable. Adding a hard drive is a relatively painless, plug-and-play operation. This is especially true if you’re adding a drive to an existing build. But upgrading your PSU isn’t always a convenient option. This way, you can get the SATA connections you need. 1X PCI-E Card exits motherboard slot at a 90 degree turn, easy cable manage for Small Form Factor Computer Case 1x adapter PCI-E c.One option is to simply purchase a newer PSU. Integrate Molex 4pin, SATA and 6-pin PCI-E power interface on PCB for direct connection to your power supply ,reduces the power burden on your motherboard and ensures maximum compatibility with your power supply.
#HDD MOLEX CONNECTOR FREE#
Thin and fast USB 3.0 cable available to connect PCI-E 1X and PCI-E 16X sides for more free installation and faster data transfer for graphics card. Multiple Voltage Regulation Components (Voltage Regulating Diode and Linear Regulator) Overcurrent Protection (Surface Mounted Fuse) to safeguard your components in the event of a short circuit. 4 High Quality Solid Capacitors for stable and safe power delivery.
0 kommentar(er)
